Substrate and preparation
The substrate must be dry, solid, absorbent, clean and free of efflorescence. Remove sintered skin from plaster surfaces mechanically. Clean chalky and very absorbent surfaces with Mineral Plaster Primer 622 pre-treat. New base coats must be at least 2-3 weeks old. Substrates with water-soluble, discolouring ingredients must be checked for suitability beforehand. If in doubt, carry out a test coat.
Processing
Always stir well before use and during application. Ideally, the paint should be applied evenly with a brush or flat brush and spread in all directions. Pre-wet highly absorbent, old lime paint coats. Depending on the substrate, apply 2-3 coats. Thin all coats with up to 20 % water. Pre-wet subsequent coats if necessary. High room air temperatures increase the water requirement. Lime Paint only achieves its full opacity when dry.
Splashability:
After appropriate Thinner and sieving of the thinned paint, LEINOS Lime Paint 665 can be applied with an appropriate airless spraying device (non-binding information). Nozzle: 0.025"-0.031", without gun filter, main filter Mesh#30, spray pressure: 150-180 bar, spray angle: 50°
Drying time
At 20 °C and 50 % relative humidity: approx. 6-12 hours. Subsequent coats after 24 hours drying time.
Consumption
1 litre is sufficient for approx. 5-8 m² per coat. The consumption is approx. 150 ml/m².
Primer for all subsequent wall coating systems on mineral substrates indoors.
Alkaline universal fixative for priming silicate and Lime Paint, solvent-free.
Fine, very white lime filler for interior use.
For the safe removal of mould indoors.
